We find the mold, kill it, and prove the attic is clean.

Attic Mold Testing And Removal in WEST HILLS, California

Attic Mold Testing And Removal in WEST HILLS, California starts with a real inspection, not a guess. We check the roof deck, rafters, insulation, and ventilation with moisture meters and thermal imaging cameras, then remove the growth and treat the wood so it stays gone. If your attic smells musty or your HVAC is pushing odd odors downstairs, call us at (833) 929-5837.

↗
Fast online booking

Request service today

Tell us what is happening. Our local team will confirm your visit shortly.

No spam. No obligation. Just practical help.
Thanks — we'll call shortly to confirm your visit.
Mold Remediation Service West Hills serving WEST HILLS, California
Careful work. Honest options.
About this service

Attic Mold Testing And Removal in WEST HILLS, California

Attic Mold Testing And Removal in WEST HILLS, California is the process of inspecting, sampling, and physically removing mold growth from the attic space, then treating the framing so it does not come back. We test the air, swab visible growth, and check the roof deck and insulation for hidden colonies. Attic mold is different from bathroom or basement mold because the attic sits above your living space, so spores can drop straight into your HVAC system and circulate through every bedroom.

Most WEST HILLS attics we open up have the same story: a slow roof leak, a clogged soffit vent, or a bathroom exhaust fan dumping warm, wet air into the attic instead of outside. Our dry climate does not stop attic mold. It just hides it. We run a full attic mold inspection WEST HILLS homeowners can trust, then handle the removal and treatment the same week. If you have been searching for attic mold remediation near me WEST HILLS, this is where it starts.

  • ✓ Stop Spores At The Source
  • ✓ Find The Water First
  • ✓ Same-Week Testing And Removal
  • ✓ Clean Enough To Breathe Again
What's included

What Attic Mold Testing And Removal Covers

Every job includes inspection, testing, containment, removal, treatment, and a clearance test. Here is what that breaks down to. If your attic needs new insulation or a roof repair, we will flag it and you can decide separately.

✓

Full Attic Inspection

A certified inspector walks the entire attic with a moisture meter, thermal imaging camera, and borescope camera. We document every affected area with photos and check the roof deck, rafters, insulation, vents, and exhaust ducts.

✓

Air And Surface Testing

We take air samples and surface swabs and send them to an accredited lab. Results come back in 24 to 72 hours with the mold genus and spore count, which tells us how aggressive the removal needs to be.

✓

Containment Setup

Plastic sheeting goes up to separate the attic from your living space, and a negative air machine with HEPA filters runs for the duration. This keeps spores from drifting down through the attic hatch while we work.

✓

Physical Mold Removal

Technicians in personal protective equipment HEPA vacuum the framing, remove contaminated insulation and drywall, and treat affected wood with Fiberlock, Concrobium, or RMR-86 depending on the surface and species.

✓

Antimicrobial Treatment

After removal we apply an antimicrobial coating to the framing and decking. This is not a cover-up. It is a residual treatment that stops any remaining spores from colonizing if moisture shows up again.

✓

Clearance Testing

We re-sample the same spots we tested before and compare the numbers. You get a written post-remediation report showing the attic passed, which is what insurers, buyers, and real estate agents want to see.

How it works

How Our Attic Mold Process Works

01

Phone Assessment

We ask about the smell, any roof leaks, and how old the home is. Most WEST HILLS homes were built between 1955 and 1995, and the older attic ventilation systems are a common culprit. We book an inspection, usually within 48 hours, and give you a two-hour arrival window.

02

Full Attic Inspection

A certified inspector walks the attic with a moisture meter, thermal imaging camera, and borescope camera. We check the roof deck, rafters, insulation, soffit vents, and every exhaust duct. Expect 45 to 90 minutes depending on attic size and how much storage is up there.

03

Testing And Lab Work

We take air samples and surface swabs, then send them to an accredited lab. Results come back in 24 to 72 hours and tell us the mold genus, the spore count, and whether you are dealing with black mold infestation or a less aggressive strain. That report drives the removal plan.

04

Containment And Removal

We seal the attic from the living space with plastic sheeting and run a negative air machine so nothing migrates downstairs. Technicians in personal protective equipment remove affected insulation and drywall, HEPA vacuum the framing, and treat the wood with Fiberlock or Concrobium. Most jobs take four to eight hours.

05

Clearance And Prevention

We apply an antimicrobial coating, seal the space back up, and run a post-remediation mold spore test. You get the lab report plus a written summary of what caused the growth and what to fix. If the roof leak or vent issue needs a repair, we tell you exactly what and where.

Tools & methods

Tools And Methods We Use

Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.

Moisture meter

Reads moisture content in roof decking, rafters, and insulation so we know exactly where the water is coming from and how far it has spread.

Thermal imaging camera

Shows temperature differences that reveal hidden damp spots behind insulation and inside rafter bays where mold grows out of sight.

Borescope camera

Slides into wall cavities and rafter bays to confirm growth in areas we cannot see directly, without cutting open the ceiling.

Negative air machine

Creates negative pressure inside the containment so spores and dust stay in the work zone instead of drifting into your living space.

Air scrubber with HEPA filters

Continuously filters the air in the containment, capturing spores down to 0.3 microns while we remove the growth.

HEPA vacuum

Pulls settled spores off framing, decking, and surfaces without blowing them back into the air the way a shop vac would.

Fogger

Applies a fine antimicrobial mist to reach framing surfaces and tight corners that a pump sprayer cannot cover evenly.

Dry ice blasting machine

Removes heavy growth from rough lumber without soaking the wood or leaving abrasive media behind in the insulation.

Real results

Before and after.

Roof Leak Fed Mold Across 400 Square Feet

Before

A failed vent boot let water into a West Hills attic for two winters. Insulation was soaked, and black mold infestation covered roughly 400 square feet of roof decking and three rafters. The upstairs hallway smelled musty year-round.

After

We pulled the wet insulation, HEPA vacuumed and treated the decking and rafters with Concrobium, and applied an antimicrobial coating. Post-remediation testing showed spore counts down 85% from the baseline. The hallway smell cleared within a week.

Bathroom Fan Dumping Steam Into A Canoga Park Attic

Before

A second-floor bathroom fan had been venting directly into the attic for years. Surface mold covered the sheathing above the bathroom, and the insulation around the duct was damp. The homeowner thought the smell was just an old house.

After

We removed the affected insulation, treated the sheathing, and re-routed the exhaust duct to an exterior termination point. Clearance testing came back clean, and the bathroom now vents outside the way it should have from the start.

Blocked Soffit Vents Caused Condensation Growth

Before

A Chatsworth home had insulation blown in over the soffit vents, cutting off intake airflow. Condensation formed on the roof deck every night and fed a thin layer of mold across most of the attic sheathing. No active leak was found.

After

We cleared the soffit channels, installed baffles to keep them open, treated the sheathing with an antimicrobial coating, and ran a full air scrub. Post-remediation testing passed, and attic temperatures dropped noticeably during the day.

Problems we solve

Attic Mold Problems We Solve In WEST HILLS

Most attic mold calls come down to a handful of root causes. Here are the ones we see most often in the west Valley and what happens if you leave them alone.

Ask a pro →
01

Musty smell in upstairs bedrooms that gets worse in summer

We test the attic air and the bedroom air on the same visit to confirm the attic is the source. Once removal is done, we run an air scrubber and verify with a post-remediation test that the spore count in the bedrooms dropped.

↗
02

Roof leak that soaked insulation months ago

We pull the wet insulation, HEPA vacuum the decking, treat the wood, and identify the leak point with a moisture meter and thermal imaging camera. You get a written note on what roof repair is needed before the attic goes back together.

↗
03

Bathroom exhaust fan venting into the attic

We confirm the vent routing during inspection, then re-route the duct to an exterior termination point. After that, the attic stays dry and the treatment we applied holds. This is one of the most common fixes we make in WEST HILLS.

↗
04

Blocked soffit vents killing attic airflow

We clear blocked vents, check that insulation is not covering the soffit channels, and note any ventilation upgrades worth making. Better airflow is the cheapest long-term mold prevention there is.

↗
Proof you can check

Licensed, Certified, And Verified

✓
IICRC CertificationInstitute of Inspection, Cleaning and Restoration Certification
✓
ACAC CertificationAmerican Council for Accredited Certification
✓
EPA Lead-Safe CertificationU.S. Environmental Protection Agency
✓
OSHA Safety TrainingOccupational Safety and Health Administration
✓
California Contractor LicenseCalifornia Contractors State License Board
Good questions

Frequently Asked Questions About Attic Mold

(833) 929-5837 →

Most attic mold removal jobs in WEST HILLS run $1,200 to $4,500 in 2026, and testing alone is $250 to $600. The price depends on attic square footage, how much insulation has to be pulled, and whether the roof deck needs treatment or replacement. Small attics with light surface growth land at the low end. Large attics with soaked insulation and heavy black mold infestation push toward the top.

Attic mold in WEST HILLS almost always comes from one of four sources: a roof leak, a bathroom or dryer exhaust fan venting into the attic instead of outside, blocked soffit vents that kill airflow, or a poorly sealed attic hatch letting warm house air rise. Our dry summers do not prevent it. A single winter rain season is enough to feed a colony that then grows all summer.

Testing takes 45 to 90 minutes on site, and lab results come back in 24 to 72 hours. The removal itself is usually a one-day job, four to eight hours for a typical WEST HILLS attic. Larger attics with heavy growth or contaminated insulation can run into a second day. You get a clearance test result within three days of the removal.

Yes. Air sampling and borescope inspection find growth behind insulation, under storage decking, and inside rafter bays where you cannot see it. We pair that with a thermal imaging camera to spot cool, damp spots that indicate a leak. Hidden mold behind insulation is the most common thing we find in WEST HILLS attics that look clean from the hatch.

Ready when you are

Book Attic Mold Testing And Removal in WEST HILLS, California

One call gets you an inspection date, a written scope, and a fixed price. We are licensed, insured, and we test before and after so you know the job is done. Call (833) 929-5837 today and we will get a technician into your attic this week.

Book An Inspection (833) 929-5837 →
Request an appointment

Contact Our West Hills Mold Team

Call us at (833) 929-5837 or send an email to schedule your free mold inspection. We answer the phone 24/7 for emergency calls and return non-urgent messages within one business day. Our office is in West Hills, California, and we serve the surrounding communities including Bell Canyon, Hidden Hills, Woodland Hills, Canoga Park, and Northridge.

Request received — our team will be in touch shortly.
Tap to call(833) 929-5837